The car paint procedure is usually done by professional automobile workshops. This task requires a variety of special equipment and safety precautions. A car owner who takes the proper safety actions can do it by his own self, and also can save thousands of dollars by doing the job at home.
So many little things can happen in a day that can smash up the paintwork of the car. A car owner may don’t even have any idea that those splatter bugs or cheeky writings with fingers on the body of a vehicle can damage the painted surface.
It is not much difficult to protect car paint. There are a few useful ways to follow. Just need to be careful and follow these tips to keep the shine intact. Again, you would want to consult with a professional car detailer:
1: Prepare Workspace:
It is crucial to ensure that one must have a clean workspace that is free of dust and garbage. A covered fitted shed with a dust extractor is the best place, but making certain that smudged areas around painting stations are cleaned and thoroughly hosed down will help to prevent blemishes.
A paint booth designed for this task is an ideal solution. If it is necessary to work outside, ensure that the weather is favorable for painting.
2: Car Wash before Paint:
It is very important to wash the car and the hose down of the surrounding area. If car owner plan to paint something with detail on specific areas of the car, block off those areas with the masking tape and paper so that the other areas could differ from damaged areas which need to be renewed.
Get rid of your junk car today: Free Car Removals
3: Power Sander:
Use the power sander to strip away the old paint, using spherical motions. The person may have to manually sand the corners and other tricky areas.
Take a start from the front of the car to back and make the surface as smooth as possible; the smoother it is, the better the paint will be finished. After sanding, mop down the whole vehicle completely. Dust, sandpaper leftovers, and other debris will cause imperfections in the paint.
4: Use Primer:
You can mix the primer with the thinner. Start to apply this primer, working from the roof down. The car surface will look perfect after two to three coats.
Each coat can be assumed approximately ten minutes for application and twenty minutes of drying time. When the coats will dry, the primer will be powdery on the surface so use the around 2000 sandpaper to smooth and wipe it down.
Clean the squirt gun and wipe down the primed surface with a rag slightly dampened with thinners. But do not apply too much thinner to the rag; the thinner will strip the primer which you have just applied.
5: Lacquer the Vehicle:
Repeat the painting steps with the lacquer, covering with 1-2 coats. Coated areas are still wet but remove any masking from areas that were not being painted. Use caution to prevent marks on a clear coat or getting tape stuck in it.
Allow the lacquer to cure for the suggested time. Once dry, check the vehicle for any blemishes or runs. Sand these down lightly and re-spray. Buff the vehicle with a buffer, making sure not to linger on one spot too long as this could burn the paint.
It doesn’t matter the steps have been taken by the car painter to ensure the evenest paint job, imperfection and mistakes can still occur. Whether the paint dries in a rough pattern, there’s a color difference, or bleeding takes place, these can be overcome by practicing more.
To paint a car does not have to be a stressful, drawn-out process. Always buy quality products, use the right tools, and have a clean, dust-free workspace, it can achieve a professional-level car paint job at home. Visit different sites for more tips, tools, products, and anything else need to get the job done right.